Add：No. 100 Jingzhou Road, Yanzhou District, Jining City, Shandong Province
SHANDONG AOLIDE ENGINEERING EQUIPMENT CO., LTD.
Master the test procedure of concrete laser leveling machine to help its good operation
The extensive use of concrete laser levelers in the construction industry is believed to have been deeply appreciated. The use of this equipment to level the ground is the best choice, regardless of the quality of the construction or the efficiency of the concrete laser. The plane is enough to surprise people. But don't forget that when you use the leveling machine for the first time, you need to carry out the test operation, which is very important for the subsequent use of the leveling machine.
▶Empty load test concrete laser leveling machine, lifting the whole stroke of the lifting motor no less than 10 times, requiring flexible transmission, accurate parking, no jamming; the main drive is rotating smoothly and positively, the sound is normal, after the empty car trial operation, Carry out the load test.
▶Adjust the position of the concrete laser leveler frame according to the width of the corrected I-beam flange plate. Adjust the correct position of the guide bar according to the thickness of the plate. Note that each side guide bar must have 2 with the web. 3mm clearance, it is absolutely forbidden to use the concrete laser leveling machine for side bend correction.
▶According to the power supply, start the concrete laser leveling machine to run empty, ensure that the parts and assemblies of each transmission part have normal operation sound, no cassette, no overheating, and can be loaded with load, and the welded H-shaped steel crane with row crane Into the roller table area, pay attention to the light workpiece, so as not to damage the drum and bearing housing.
▶Start the drive roller and transport the I-beam into the concrete laser leveling machine. The end exceeds the laser leveling machine. When the end exceeds the center of the correction wheel, it will stop after about 150mm. Press the 1#, 2# upper roller to lower the linkage. Immediately after the pressure roller contacts the workpiece, stop it by pressing 1#, 2#, and press the upper and lower pressure rollers. The amount of reduction may be in error and can be adjusted at any time.
▶ Correctly adjust the amount of reduction. The dial of the screw is indicated as 0.5mm per grid, and the amount of over-deformation under pressure must not exceed 1mm. However, the adjustment of the upper press roller can only be carried out during the stop, and the workpiece is output to the host position of about 200 mm, and the flange plate after the initial correction is detected to be perpendicular to the web to prevent overcorrection.
▶If you need to adjust the correction amount of Liaoning concrete laser leveling machine, retract the workpiece into the main unit (the end is more than 150mm beyond the center of the correction wheel) to adjust the reduction of the correction roller, start the main drive motor, and perform normal correction output. If multiple corrections are required on one side, the delivery should be stopped immediately at the end of the workpiece about 100 mm from the center of the correction wheel.